Energizer 12V Jump-Start System

A jump for your vehicle wherever you are. 12A battery delivers 200 CA. Rugged polypropylene case. Ergonomic handle; doubles as protective housing for docked clamps. Low center of gravity for stability during use. 6 gauge cables, 19" reach. Heavy-duty, 400A insulated metal battery clamps. Two-stage internal charger allows jump starter to remain connected to wall outlet indefinitely; keeping internal battery charged at all times. Easy-to-operate ON/OFF switch to prevent sparking. 12V DC socket for operating accessories; protected by 15A circuit breake

Jumpstarting Your Car

In the event of a dead or severely drained battery the Energizer Jumpstart 200 allows you to get back on the road in minutes by simply following three color-coated steps numbered on the outside of the unit. It's as easy as 1: assuring that the unit has a sufficient charge by pressing the CHECK button; 2: attaching the color-coded positively and negatively charged 18" power output jumper cables, via their heavy-duty 200A plastic battery clamps, to the appropriate positively charged post on your car's dead battery and a ground position on your engine block; 3: turning the power switch located in the clearly marked JUMP section of the controls from OFF to JUMP, and starting the car with the dead battery. When your vehicle starts and has run at an idle for a few minutes remove the Jumpstart 200's cables in the reverse order they were connected, turn off the unit and you are ready to roll.

DC Power For Devices When You Need It

Along with its automotive exclusive functionality, the Energizer Jumpstart 200 provides the power that users of modern devices often will find that they need on the road. The unit comes standard with one rear-oriented 12-volt DC socket suitable for powering 12V accessories utilizing a cigarette lighter adapter. Devices plugged into this are protected by a 15-amp manual-reset circuit breaker located at the back, that ensures that they are never exposed to more power than they can safely handle.

Easy to Maintain Power Levels

Because even the best jumpstarter unit is of little use unless it contains sufficient power, the Energizer Jumpstart 200 is designed to be easy to charge and effortless to maintain. Unlike other manufacturer's units that can be damaged by overcharging, the Energizer Jumpstart 200 contains a two-stage internal charger that allows your battery's power to fluctuate within a very small range while attached to AC current for charging. At the highest level of this range through the middle, charging ceases, while when the lowest is reached charging begins again, continuing until the highest level is reached. This creates a charging cycle, yet cuts the battery off from the damaging effects of excess power. This means that the unit can safely be connected to a wall outlet indefinitely, ensuring that the unit will be ready to pop into your trunk at full power whenever you want it.

Features:

• 12Ah battery delivers 200 CA
• Rugged polypropylene case
• Low center-of-gravity for stability during use
• 8AWG copper cables 18" reach
• Heavy-duty 200A, plastic battery clamps
• Two-stage internal charger allows jumpstarter to remain connected to wall outlet indefinitely; keeping internal battery charged at all times
• Easy-to-operate ON/OFF switch to prevent sparking
• 12-volt ciga 12Ah battery delivers 200 CA